Elazta Base – Tatiana

ELAZTA BASE - RUBBER BASE COVER

Discover a new range of RUBBER BASE COVER with an ideal formulation, perfectly suited to reinforcement protocols, mini-gainage, babyboomer, babyglittter and other macro-manicures. Its semi-fluid, totally self-levelling and slightly elastic texture lets you work the material effortlessly .

A perfect RUBBER BASE for the NO LIMAGE technique: applied with precision, ELAZTA BASE guarantees an ultra-fine result.

Available in a wide range of ultra-trendy NUDE shades with adjustable coverage, our RUBBER BASE COVER will adapt to all skin tones to satisfy and beautify the hands of your customers with soft to hard nails .

ELAZTA BASE, by virtue of its formulation, is suitable for soft to rigid nails and can be removed extremely effectively with a melting solution (or mechanically).

APPLICATION PROTOCOL

- Shake the bottle for a few seconds before use
- Unscrew the cap
- Remove excess material by scraping the brush inside the screw thread
- Apply a thin, well-stretched first coat, over the entire plate, 2mm from the cuticles
- Do not catalyze
- Place a drop of material at the apex
- Stretch and work this drop with a liner until the desired result is obtained
- Catalyze for the time indicated(see MORE INFO tab).

TIPS

After catalysis,ELAZTA BASE leaves little sticky residue:

- to apply your foils easily on our ELAZTA BASE, we recommend using our UNIVERSAL FOIL GEL, which guarantees a perfect grip.

- if you wish to use it UNDER a contruction (Gel/Acrygel), it is imperative to degrease and roughen it with a white block to enable the material to grip.

ELAZTA BASE is perfectly compatible with all our finishes, especially our SUPRASHINE finish, so there's no need to degrease before applying it.

CAUTION

Applying ELAZTA BASE in too thick a coat can impair its catalytic action: depending on your type of lamp and its generation/power/age, you' d be better off applying ELAZTA BASE in several thin, catalyzed coats than in a single, thick coat .

ELAZTA BASE must be catalyzed for at least 60s, even in thin coats: we advise against pre-catalyzation, which can generate unsightly wrinkles.

As with all technical products, the viscosity of ELAZTA BASE varies according to ambient temperature: it thins with heat and thickens with cold. Remember to store and use your bases in an environment of around 25°C or, failing that,adapt your protocol.

*Due to its flexibility, ELAZTA BASE is not suitable for extensions!

ADDITIONAL INFORMATION

The Oval color chart shown in the image was produced with our ELAZTA BASE applied in two thin coats and photographed in daylight. The photo of the open bottle was taken in a studio - under white LED light.

For American layering, use our FIBR'IN BASE.